Download Print this page
HP ZR30w Technical Specifications

HP ZR30w Technical Specifications

30-inch s-ips lcd monitor
Hide thumbs Also See for ZR30w:

Advertisement

Quick Links

QuickSpecs
Overview
1. Source
Selects the video input (DisplayPort or DVI-
D)
2. - (Minus)
Reduces the brightness setting
3. + (Plus)
Increases the brightness setting
NOTE: Pressing the + (Plus) and - (Minus) buttons at the same time enables or disables the Dynamic Contrast Ratio (DCR) function.
When enabling the DCR function, the power LED will flash four times. When disabling the DCR function, the power LED will flash one
time.
Model
VM617A4
DA - 13635 North America — Version 9 — January 29, 2013
HP ZR30w 30-inch S-IPS LCD Monitor
4. Power
Turns the monitor on or off
5. Power LED
Sleep mode - amber; Continuous flashing
blue - non-supported video mode; Three
flashes of blue - upper or lower limit of
brightness control; Four flashes of blue -
DCR is enabled; One flash of blue - DCR is
disabled; Steady blue - full power and
monitor is displaying a supported mode
(LED automatically turns off after 30
seconds)
Page 1

Advertisement

loading

Summary of Contents for HP ZR30w

  • Page 1 QuickSpecs HP ZR30w 30-inch S-IPS LCD Monitor Overview 1. Source Selects the video input (DisplayPort or DVI- 4. Power Turns the monitor on or off 2. - (Minus) Reduces the brightness setting 5. Power LED Sleep mode - amber; Continuous flashing blue - non-supported video mode;...
  • Page 2: Technical Specifications

    Host Graphics Card: Must be able to provide a resolution of 2560 x 1600 @ 60Hz (check host QuickSpecs) a. Note for graphics cards with DMS-59 interface - to drive the ZR30w with DMS-59: Graphics card DMS-59 output must have DisplayPort support (check QuickSpecs)
  • Page 3 QuickSpecs HP ZR30w 30-inch S-IPS LCD Monitor Technical Specifications Performance Vertical Frequency 60 Hz Native Resolution 2560 x 1600 @ 60 Hz Preset VESA Graphic 2560 x 1600 @ 60 Hz Modes (non-interlaced) Text Mode Not Supported Maximum Pixel Clock...
  • Page 4: Additional Information

    This product is in compliance with the Restrictions of Hazardous Substances (RoHS) directive - 2002/95/EC. This HP product is designed to comply with the Waste Electrical and Electronic Equipment (WEEE) Directive - 2002/96/EC. This product is in compliance with California Proposition 65 (State of California;...
  • Page 5 RoHS Directive on a worldwide basis. By July 1, 2006, RoHS substances will be virtually eliminated (virtually = to levels below legal limits) for all HP electronic products subject to the RoHS Directive, except where it is widely recognized that there is no technically feasible alternative (as indicated by an exemption under the EU RoHS Directive).
  • Page 6 (included) QuickSpecs document. * The HP Quick Release has been designed to support a maximum of up to 24 lbs (10.9 kg) for all devices mounted. Because mounting surfaces vary widely and the final mounting method and configuration may vary, mounting fasteners are not supplied (other than the VESA-compliant screws). HP recommends that...
  • Page 7 HP Care Packs may vary depending on your geographic location. Service starts from date of hardware purchase. To choose the right level of service for your HP product, use the HP Care Pack Services Lookup Tool at: http://www.hp.com/go/lookuptool. Additional HP Care Pack Services information by product is available at: http://www.hp.com/hps/carepack.

This manual is also suitable for:

Vm617a4