Mounting the Monitor Panel
You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture.
CAUTION:
power and signal cables are both disconnected. If the monitor has a connected audio cable, disconnect
it.
1.
Disconnect and remove the signal and power cables from the back of the monitor.
2.
Lay the monitor face down on a flat surface.
3.
Remove the two screws on the back of the monitor that connect the monitor panel to the pedestal
base (1) and slide the pedestal base from the monitor panel (2).
Figure 3-5
8
Chapter 3 Setting Up the Monitor
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
Removing the Pedestal Base