Using The Accessory Rails; Mounting The Monitor Panel - HP Compaq LE1711 User Manual

When the monitor is powered on, a Monitor Status message is displayed for five seconds. The message
shows the current active input signal, the current preset display resolution, and the recommended preset
display resolution.

Using the Accessory Rails

The monitor features accessory rails on the rear that can be used to mount optional devices, such as
the HP speaker bar, to attach to the LCD. Refer to the documentation included with the optional device
for detailed mounting instructions.
Figure 3-5

Mounting the Monitor Panel

You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture. Four threaded mounting holes are provided on the monitor back panel to be
used for mounting purposes.
CAUTION:
power and signal cables are both disconnected.
1. Disconnect and remove the signal and power cables from the back of the monitor.
2. Lay the monitor face down on a flat surface covered by a dry, clean cloth.
8 Chapter 3 Setting Up the Monitor
Using the Accessory Rails Feature
Before beginning to disassemble the monitor, be sure the monitor is turned off and the