Sleep Timer Mode - HP ZR2040w User Manual

To eliminate vertical bars (Clock):
1.
Press the
Control > Clock.
2.
Press the
the buttons slowly so that you do not miss the optimum adjustment point.
Figure 4-4
3.
After adjusting the Clock, if blurring, flickering, or bars appear on the screen, proceed to adjust
the Clock Phase.
To remove flickering or blurring (Clock Phase)
1.
Press the
Control > Clock Phase.
2. Press the
blurring. Flicking or blurring may not be eliminated depending on your computer or graphics
controller card installed.
Figure 4-5
To correct screen position (Horizontal Position or Vertical Position):
1. Press the
Control > Horizontal Position and/or Vertical Position.
2.
Press the
of the image in the display area of the monitor. The Horizontal Position shifts the image left or
right; the Vertical Position shifts the image up and down.
Figure 4-6

Sleep Timer Mode

You can set your computer to sleep when not in use, and this will cause the monitor to sleep (unless you
disable low-power mode). In addition, some monitors support a sleep timer, an energy-saving feature
that enables you to set daily times for the monitor to go into low-power mode and wake up again. This
38 Chapter 4 Operating the Monitor
Menu button on the monitor's front panel to open the OSD Menu, and then select Image
+ (Plus) or — (Minus) buttons on the monitor's front panel to eliminate vertical bars. Press
Adjusting the Clock
Menu button on the monitor's front panel to open the OSD Menu, and then select Image
+ (Plus) or — (Minus) buttons on the monitor's front panel to eliminate flickering or
Adjusting the Clock Phase
Menu button on the monitor's front panel to open the OSD Menu, and then select Image
+ (Plus) or — (Minus) buttons on the monitor's front panel to properly adjust the position
Adjusting the Image Position
ENWW