Download  Print this page

Turning On The Monitor; Mounting The Monitor Panel - HP LE2201w User Manual

Hide thumbs

Advertisement

Turning on the Monitor

1.
Press the power button on the computer to turn it on.
2.
Press the power button on the front of the monitor to turn it on.
CAUTION:
screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen, you
should always activate a screen saver application or turn off the monitor when it is not in use for a
prolonged period of time. Image retention is a condition that may occur on all LCD screens. Monitors
with a "burned-in image" are not covered under the HP warranty.
* A prolonged period of time is 12 consecutive hours of non-use.
NOTE:
If pressing the power button has no effect, the Power Button Lockout feature may be enabled.
To disable this feature, press and hold the monitor power button for 10 seconds.

Mounting the Monitor Panel

You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture. Four threaded mounting holes are provided on the monitor back panel to be
used for mounting purposes.
CAUTION:
power and signal cables are both disconnected. If the monitor has a connected audio cable, disconnect
it.
1.
Disconnect and remove the signal and power cables from the back of the monitor.
2.
Lay the monitor face down on a flat surface.
3.
Remove the three screws on the back of the monitor that connect the monitor panel to the pedestal
base (1) and slide the pedestal base from the monitor panel (2).
Figure 3-4
8
Chapter 3 Setting Up the Monitor
Downloaded from ManualMonitor.com Manuals
Burn-in image damage may occur on monitors that display the same static image on
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
Removing the Pedestal Base
ENWW

Advertisement

Table of Contents

   Also See for HP LE2201w

   Related Manuals for HP LE2201w

This manual is also suitable for:

Le1901wmLe1901w

Comments to this Manuals

Symbols: 0
Latest comments: