Mounting The Monitor Panel - HP LE1851w - Widescreen LCD Monitor User Manual

Mounting the Monitor Panel

You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture. Four threaded mounting holes are provided on the monitor back panel to be
used for mounting purposes.
NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
CAUTION:
power and signal cables are both disconnected.
1. Disconnect and remove the signal and power cables from the back of the monitor.
2. Lay the monitor face down on a flat surface.
3. Remove the four screws on the back of the monitor that connect the monitor panel to the pedestal
base (1) and slide the pedestal base from the monitor panel (2).
Figure 3-7
ENWW
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
Removing the Pedestal Base
Mounting the Monitor Panel 9