Clearing Password
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare
2.
Pull the server out from the rack (see Chapter 9).
3.
Remove the top cover (see Chapter 9).
4.
Verify the location of password clear jumper switch.
5.
Change jumper switch setting from "Protect" to "Clear".
6.
Reassemble the server, and press the POWER switch to turn on the server.
7.
Press F2 during POST to run the BIOS Setup utility, and set the password again.
8.
Power off the server, and change jumper switch setting from "Clear" to "Protect".
9.
Reassemble the server.
Configuring Your Server 4-53