Rear View - NEC N8100-14522F User Manual

Rear View

1
1 AC inlet
Connect the AC power cord to this socket.
2 Mouse connector
The connector is used to connect a PS/2 mouse.
3 LINK/ACT LED (green)
The ACT/LINK LED is lit green when the network port is being linked with the connected device
such as a hub (LINK state). If a data is transferred through a network port, the LED blinks green
(ACT state).
4 Management LAN port
This LED indicates the transfer rate of the LAN port.
5 100/10 LED
This LED indicates the transfer rate of management LAN port.
6 USB connectors 1/2
The connector is used to connect a device compliant with the USB interface. The last digit
number "1" indicates connector 1, and the number "2" indicates connector 2.
7 1000/100/10 LED
This LED indicates the transfer rate of LAN port.
8 PCI board extension slot
Install the optional PCI board into these slots.
8-1 Low-profile PCI board
8-2 Full-height PCI board
9 Keyboard connector
The connector is used to connect a PS/2 keyboard.
10 Serial port (COM A) connector
The connector is used to connect a device with the serial interface.
11 Monitor connector
The connector is used to connect a display unit.
12 LAN connectors
The connectors are used to connect the network systems on LAN through 1000BASE-
T/100BASE-TX/10BASE-T interface.
The last digit number indicates LAN port number.
* The number may differ from that shown on OS.
13 UID (Unit ID) switch / UID LED (blue)
Press the UID switch to turn on/off the UID LEDs on the front and rear panels of the server. The
LED blinks when software issues a command.
2 3 4 5 6-1
9 6-2 10
6 3 7 3 7 8-1
11 12-1 12-2 13
General Description 2-5
8-2