NEC N8100-14522F User Manual page 270

D-8 Installing Windows Server 2003 x64 Editions
8.
Select the proper SCSI Adapter and press Enter.
– [LSI MegaRAID SAS RAID Controller Driver (Server 2003 for x64)]
(When N8103-116/117/118 RAID controller is installed.)
– [LSI Embedded MegaRAID (Windows XP/2003 64-bit)]
(When LSI Embedded MegaRAID is used.)
Continue performing tasks according to the subsequent messages that appear.
9.
If you utilize N8103-75/107, press S.
A list of mass storage devices is displayed.
Select the [Adaptec Ultra320 SCSI Cards (Windows 64-bit)] and press Enter.
10.
When the following message is shown, press Enter to start "Welcome to Setup".
IMPORTANT:
the hard disk larger than 2,097,152MB (2TB), you can specify only a
value equal to or less than 2,097,152MB as partition size.
11.
When the installation of Windows Server 2003 x64 Editions has finished, the system
reboots automatically.
12.
The [Windows Setup] screen will be displayed after logged on to the system.
IMPORTANT:
In this case, the [Windows Setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 x64 Edition
DISC 2 according to the following procedures.
You can install Microsoft Windows Server 2003 R2 x64 Edition
DISC 2 after the application of "System update".
Be sure to install Microsoft Windows Server 2003 R2 x64 Edition
DISC 2.
In this case, note that the [Windows Setup] screen is not displayed.
If you install Windows Server 2003 x64 Editions on