NEC N8100-14522F User Manual page 85

Security
Press Enter on "Set Supervisor Password" or "Set User Password," to display the password entry
screen.
Enter the passwords on the dialog box.
IMPORTANT:
User password can be set only when Supervisor password is already
set.
Set the passwords only after OS is installed.
If you forget the passwords, contact your service representative.
Option
Supervisor
Password Is
User Password Is
Set User
Password
Set Supervisor
Password
Password on boot
Fixed disk boot
sector
Power Switch
Inhibit
Disable USB Ports
Parameter
Clear
Set
Clear
Set
Up to eight
alphanumerics
Up to eight
alphanumerics
[Disabled]
Enabled
[Normal]
Write Protect
[Disabled]
Enabled
[Disabled]
Front
Rear
Front + Rear
Description
Indicates the password setting status.
Indicates the password setting status.
Press Enter to display the user
password entry screen. For this
password, accessing to the SETUP
menu is restricted.
Press Enter to display the supervisor
password entry screen. This password
enables all the SETUP menus to be
accessed. This setting can be done
only on login with the password input
of "Supervisor" at start of SETUP.
Specify whether the passwords are
entered or not on booting. At first the
supervisor password must be set. If
the supervisor password is set and
this option is disabled, BIOS
determines that a user is booting.
Specify whether to permit writing into
boot sector of the IDE hard disk drive
or not. The server does not support
IDE hard disk drive.
Specify whether to enable or disable
the power switch feature.
(Forced shutdown (pressing the
POWER switch for at least four
seconds) feature is always acceptable
to the server.
Select the USB port to be disabled or
enabled.
Configuring Your Server 4-17
Your Setting
[ ]: Factory-set