Installation Order - NEC N8100-14522F User Manual

Installation Order

The following conditions must be met:
Install two DIMMs in pair.
Two DIMMs must be of same density, same capacity.
Two DIMMs must be installed in slots #6 and #5, #4 and #3, or #2 and #1.
Installation
Install a DIMM in the following procedure.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Open the levers at both ends of the socket, and push the DIMM to the socket straight.
NOTE:
the DIMM has key and key slot to prevent incorrect insertion.
If the DIMM is inserted into the DIMM socket, the lever is automatically closed.
1.
Install the components removed in Step 1.
2.
Turn on the power of the server. Make sure that no error message appears in the POST.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 8.
3.
Run the BIOS SETUP and select [Advanced] → [Memory Configuration] to verify that
the installed DIMM shows the status "Normal". (See Chapter 4 for details.)
4.
Select "Yes" for [Reset Configuration Data] on the [Advanced] menu.
This is required to update the hardware configuration information. See Chapter 4 for
details.
5.
If Windows Server 2003 is in use, set the paging file size to the recommended value or a
greater value. See Chapter 5 for details.
Key slot
Key
Make sure of the orientation of DIMM. The terminal side of
Upgrading Your Server 9-13