NEC N8100-14522F User Manual page 61

Removal
Remove the server from the rack in the following procedure.
1.
Make sure that the server is off-powered, and disconnect the power cords and all the
interface cables from the server.
2.
<This step is required only when the optional cable arm is mounted.>
Remove the cable arm from the server.
3.
While pushing the left and the right unlock buttons on the front of the server, pull out the
server from the rack slowly and carefully.
IMPORTANT:
the rack. Doing so may cause personal injury if the server drops.
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-3 to 1-11 for details.
Do not install/remove the server in/from the rack only by a single person.
Do not pinch your finger with mechanical components.
Do not apply any load on the server being pulled out from the rack.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
Do not pull out the server from the rack while it is operating.
Press this button to
unlock the server.
Do not apply any load on the server pulled out from
Setting Up Your Server 3-11
CAUTION