Using The Tmcat17 Switch; Opening Tmcat17 - Raritan TMCAT17 Quick Setup Manual

c. Plug the MCIM or MCUTP's video connector into the
computer's VGA port.
- OR -
 If using the Sun USB MCUTP cable:
a. Plug the MCUTP's Sun USB connector into one of the
available USB ports on the Sun server.
b. Plug the MCUTP's video connector into the VGA port on
the Sun server.
Note: See Supporting Sun Servers in the User Guide for
more information.
3. Connect the computer to the TMCAT17 switch.
 If using the MCIM:
a. Plug one end of a Cat5 UTP cable into the RJ-45 port of
the MCIM being connected with the computer.
b. Plug the other end of the Cat5 UTP cable into one of the
channel ports on the TMCAT17 switch.
TMCAT QSG
QSG-TMCAT-0D-v1.0-E  255-37-0122-00 RoHS
 If using the MCUTP cable:
 Plug the MCUTP cable's RJ-45 connector into one
of the channel ports on the TMCAT17 switch.
4. Repeat Steps 2 to 3 to connect more computers.
5. (Optional) Connect the MCCAT user station to the User 2
port on the TMCAT17 switch via a standard Cat5 UTP
cable. For more information, see the Quick Setup Guide
shipped with the user station or the section titled
Connecting a User Station (Optional) in the User Guide.
Tip: The TMCAT17 switch is compatible with the Paragon
II enhanced user station, P2-EUST. If you have P2-EUST,
you can connect it, instead of the MCCAT user station, to
the TMCAT17 switch.
6. Connect an appropriate power cord to every device in the
system.
QS Rule

Using the TMCAT17 Switch

Opening TMCAT17

This section describes how to physically open the LCD KVM
switch when it is installed in a rack.
Note: The diagrams are for illustration, and may not look
exactly the same as the LCD KVM switch you purchased or the
rack in your workplace.
4