Ford Mercury Villager 1997 Owner's Manual page 37

Radio Controls
How to turn the radio on and off
Press the "VOL-PUSH ON" knob or the "AM/FM" button to
turn on the radio. Press the "VOL-PUSH ON" knob again to turn
it off.
How to adjust the volume
Turn the "VOL-PUSH ON" knob to increase/decrease volume.
Bars illuminate in the display to show the relative volume level.
NOTE: If the volume level is set above a certain listening
level when the ignition switch is turned off, when the
ignition switch is turned back ON, the volume will
come back to a "nominal" listening level. However, if
the radio power is turned off, the volume will remain in
the position it was set at when radio power is
switched back on.
Selecting the AM or FM frequency band
Push the "AM/FM" button to select the desired frequency band.
When in the radio mode, pushing the button more than once
will alternate between AM, FM1 and FM2. These functions are used
with the station memory buttons described under How to tune
radio stations.
How to tune radio stations
There are four ways for you to tune in to a particular station on
the radio. You can manually locate the station by using the
"TUNE" function, "SEEK" to the station, "SCAN" to the station
or select the station by using the memory buttons, which you
can set to any desired frequency.
Using the "TUNE" button to select the tune function
Electronic Sound Systems
33