Ford Mercury Villager 1997 Owner's Manual page 160

Using the Automatic Locking Mode Retractor to Secure
a Child Safety Seat
Your vehicle is equipped with a dual locking mode retractor on
the shoulder belt portion of the combination lap/shoulder safety
belt for the front passenger seat and rear outer seats. The
automatic locking mode must be used when installing a child
seat or infant carrier in the front passenger seat or rear outer seats.
To install a child safety seat or infant carrier, follow these steps:
1. Position the child seat or infant carrier in the vehicle seat. If you
are using the moveable third row seat in the third row
position, the passenger side second row bucket seat, or the
front passenger seat, slide the seat to the rearmost position.
2. Follow the child seat or infant carrier manufacturer's
instructions. Route the safety belt through the child seat or
infant carrier and insert the safety belt tongue into the buckle
until you hear and feel the latch engage. Be sure to follow
the child safety seat manufacturer's instructions for belt
routing. When using the seating position near the sliding door
on the two-passenger bench seat, be sure that the single
window tongue is attached to the auxillary buckle on the side
of the seat.
156