Sound (Beep) Guide Function; Setting The External Digital Input; Setting The Aux Mode (V-Link); Connecting To An External Amplifier - Alpine CDA-137BTI Owner's Manual

 Setting item: Play Mode
Setting contents:
CD-DA (Initial setting) / CDDA&MP3/WMA
CD-DA:
Only the CD data in Session 1 can be played back.
CDDA&MP3/WMA:
CD data, MP3/WMA/AAC files in mixed mode, and multi-session
discs can be played back.
Note
• Perform this setting before inserting a disc. If a disc has already been
inserted, remove it first. (If you use an MP3 changer, you have to
change discs.)

Sound (Beep) Guide Function

 Setting item: Beep
Setting contents:
OFF / ON (Initial setting)

Setting the External Digital Input

ENTER
ENTER
Rotary encoder
 Setting item: Digital AUX
Setting contents:
OFF (Initial setting) / ON
Notes
• Press SOURCE, and select the D.Aux mode, and adjust the volume,
etc.
• After input selection is completed, turn the ignition off and back on
again. Setting of the optical digital input switch is completed.
• Depending on the connected audio processor, DVD player sound may
continue to be output, even though the source is changed to another
one. If this occurs, set the DVD player's power to OFF.

Setting the AUX Mode (V-Link)

ENTER
Rotary encoder
Rotary encoder
 Setting item: AUX IN
Setting contents:
OFF (Initial setting) / ON
OFF:
When set to OFF, AUX source cannot be selected.
Rotary encoder
ENTER
ON :
Set to ON when a portable device is connected. If SOURCE is
pressed and AUX is selected, the sound of the portable device is
input to the unit.
You can change the AUX Name display when AUX IN is set to
ON. Press ENTER when AUX IN is set to ON, and select
AUX Name by turning the Rotary encoder, then press
ENTER. After that, turn the Rotary encoder to select the
desired AUX Name.
Note
• Via KCA-410C, up to 2 external devices with RCA output can be
connected. In this case, press SOURCE to select AUX mode and
then press BAND to select your desired device.

Connecting to an External Amplifier

 Setting item: Power IC
Setting contents:
OFF / ON (Initial setting)
OFF :
Use this mode when the line output of this unit is used to drive an
external amplifier. In this setting, the head unit's internal amplifier
is turned OFF and can not drive speakers.
ON :
The speakers are driven by the built-in amplifier.
POWER IC OFF:
Amplifier
Amplifier
POWER IC ON:
SPEAKER
RIGHT FRONT
SPEAKER
RIGHT REAR
SPEAKER
LEFT REAR
SPEAKER
LEFT FRONT
Note
• No sound is produced by the system when the Power IC is set to OFF.
Front
Left
Front
Right
Rear
Left
Rear
Right
Speakers
Front
Right
Rear
Right
Rear
Left
Front
Left
23
-EN