Installation; Removal; Ipod/Iphone Connection (Sold Separately) - Alpine CDA-137BTI Owner's Manual

Installation

Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
Less than 35°
1
Remove the mounting sleeve from the main unit (refer to
"Removal" on page 53). Slide the mounting sleeve into the
dashboard and fix it with the metal shackles.
Bracket
Mounting Sleeve
Dashboard
(Included)
*
Pressure Plates
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
When your vehicle has the Bracket, mount the long hex
bolt onto the rear panel of the CDA-137BTi and put the
Rubber Cap on the hex bolt. If your vehicle does not have
the Mounting Support, reinforce the head unit with the
metal mounting strap (not supplied). Connect all other
leads of the CDA-137BTi according to details described in
the CONNECTIONS section.
Metal Mounting Strap
*
Hex Nut (M5)
Note
• For the screw , provide a proper screw to the chassis installing location.
Detachable Front
Panel
Rubber Cap
(Included)
Hex Bolt
(Included)
This unit
Screw
Bolt Stud
This unit
3
Slide the CDA-137BTi into the dashboard. When the unit is
in place, make sure the locking pins are fully seated in the
down position. This can be done by pressing firmly in on
the unit while pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly locked
and will not accidentally come out from the dashboard.
Install the detachable front panel.

Removal

1
Remove the detachable front panel.
2
Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
3
Pull the unit out, keeping it unlocked as you do so.
JAPANESE CAR
This unit

iPod/iPhone Connection (sold separately)

Interface cable for iPod (supplied)
Lock Pin
Front Frame
Screws (M5 × 8)
(Included)
Mounting Bracket
USB cable
53
-EN