Getting Started; Accessory List; Turning Power On And Off; Source Selection - Alpine CDA-137BTI Owner's Manual

Getting Started

SOURCE/
Rotary encoder
y
/ENTER/DIMMER

Accessory List

• Head unit ..................................................................................1
• Power cable...............................................................................1
• USB Cable..................................................................................1
• Interface cable for iPod............................................................1
• Microphone ..............................................................................1
• Mounting sleeve.......................................................................1
• Carrying case ............................................................................1
• Rubber Cap ...............................................................................1
• Hex Bolt.....................................................................................1
• Screw (M5 × 8) ..........................................................................4
• Remote Control ........................................................................1
• Battery (AAA size).....................................................................2
• Owner's Manual..................................................................1 set

Turning Power On and Off

Press SOURCE to turn on the unit.
Note
• The unit can be turned on by pressing any other button except y.
Press and hold SOURCE for at least 2 seconds to turn
off the unit.
Note
• The first time power is turned on, the volume will start from level 12.

Source Selection

Press SOURCE to change the source.
TUNER  DISC  USB/USB iPod
*3 *4
 AUXILIARY
CHANGER
Displayed only when the iPod/iPhone is connected.
Displayed only when Bluetooth Audio is set to ON, refer to
"Setting the BLUETOOTH Connection (Bluetooth IN)" on
page 27.
Only when the CD changer is connected.
Displayed only when the AUX IN is set to ON, refer to "Setting
the AUX Mode (V-Link)" on page 23.
SETUP
*1 *2
 Bluetooth Audio 
 TUNER

Detaching and Attaching the Front Panel

Detaching

1
Turn off the unit power.
2
Press y (OPEN) to open the front panel (figure 1).
To close the front panel, press the left side until it locks as shown
in the figure 2.
figure 1
3
Grasp the front panel firmly, slide to the left , and then
pull  to remove.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.
• Do not leave the front panel open, or drive the car with the panel open
as it may result in an accident or malfunction.

Attaching

1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
figure 2
9
-EN