Multi-Zone Connections And Operations; Multi-Zone Connections - Denon AVP-A1HDE Owner's Manual

Multi-Zone Connections and Operations

Multi-Zone Connections

• For ZONE2, it is necessary to set in sequence with the signal connected to either the power amplifier or bit stream amps.
The amp should be the power amplifier in the case of ZONE3, and the bit-stream for ZONE4.
• If the signal inputted to ZONE2 is analog, change to PCM(2-channel) signal, and output it from ZONE2 optical output connectors.
Connectors for audio output
ZONE2 PRE OUT
ZONE2
ZONE2 OPTICAL OUT
ZONE3 ZONE3 PRE OUT
ZONE4 ZONE4 OPTICAL4 OUT
MAIN ZONE (7.1-channel system)
Monitor
ZONE2 video
AVP-A1HD
DVD player
output
Input
ZONE3 video
Power amplifier
output
Remote
control unit

Audio signals
Stereo
Bit-stream
Stereo
Bit-stream
ZONE2
Monitor
AV amplifier
or
Power amplifier
ZONE2 audio
output
ZONE2 digital output
ZONE3
Monitor
Power amplifier
ZONE3 audio output
Connectors for video output
ZONE2 VIDEO OUT,
ZONE2 S-VIDEO OUT,
ZONE2 COMPONENT VIDEO OUT
ZONE3 VIDEO OUT
–
ZONE4
AV amplifier
ZONE4
digital output
: Video cable
: Audio cable
• When only using one speaker for ZONE2 or ZONE3, set to "Mono" .
In this case, the ZONE2 (ZONE3) monaural output is output from
the ZONE2 (ZONE3) pre-out L and R connectors, so connect as
desired.
• Separate power amplifiers are needed for ZONE2 and ZONE3.