Xlr Out Polarity; Poa Setting; Volume Control; Source Delete - Denon AVP-A1HDE Owner's Manual

s XLR Out Polarity
Set to switch the XLR pre-out terminal polarity.
[Selectable channels]
Front L Front R Center Surround A L Surround A R
Surround B L Surround B R Surround Back L
Surround Back R Subwoofer 1 Subwoofer 2
[Selectable items] XLR qGROUND
wHOT
eCOLD
XLR (INV)
qGROUND
wCOLD
eHOT
d POA Setting
Set when connecting the receiver to a POA-A1HD.
POA LINK
Set when connecting the receiver to a POA-A1HD through a CONTROL
LINK.
OFF ON (Single) ON (Dual)
[Selectable items]
POA 1/POA 2
Set POA-A1HD for which the MODE select switch is set to "1" or "2" .
See the POA-A1HD operating instructions.
n Input Selector
Select the setup channel.
[Selectable items] L1 R1 L2
L4 R4 L5
Select the connector input to be used for each channel.
[Selectable items] RCA XLR OFF
0
n Power Amp
Select the setup channel.
[Selectable items] L1/L2
Set the power amp usage for each channel.
[Selectable items] NORMAL
Subwoofer 3
LINK Check
Check CONTROL LINK.
f Volume Control
Set the MAIN ZONE volume setting.
Volume Limit
Make a setting for maximum volume.
[Selectable items]
Power On Level
This sets the volume set when the MAIN ZONE's power is turned on.
[Selectable items] Last
Mute Level
This sets the amount of attenuation of the volume when the mute
mode is set in the MAIN ZONE.
[Selectable items]
g Source Delete
Remove input sources that are not used from the display.
[Selectable items]
R2 L3 R3
R5
NOTE
• Input sources being used in the various zones cannot be deleted.
• Input sources set to "Delete" cannot be selected from GUI menu
"Source Select" or using the
SOURCE SELECT
or
L3/L4 L5/R5 R1/R2 R3/R4
BI-AMP BRIDGE (BTL)
OFF –20dB –10dB 0dB
– – –dB
–80dB ~ 18dB
Full –40dB –20dB
ON Delete
SOURCE SELECT
knob on the main unit
button on the remote control unit.
h GUI
Make GUI related settings.
Screensaver
Make screensaver settings.
Use the screensaver to prevent burn-in on the monitor screen.
When set to "ON" , the screensaver is activated if there is no activity
for about 3 minutes.
[Selectable items] ON OFF
Wall Paper
Change the GUI background.
[Selectable items] Picture Black Gray
Format
Select the video output signal format to match the monitor.
[Selectable items] PAL NTSC
NOTE
When a format other than the video format of the connected monitor
is set, the picture will not be displayed properly. Use the procedure
described below to change the video format.
Operating from the main unit
b The GUI menu is not displayed when performing this setting.
AUDIO DELAY RETURN
q Press and hold the and
seconds.
"Video Format" appears on the display.
w Use the o p button to make the setting.
ENTER MENU RETURN
e Press the , or button to complete the
setting.
Blue
buttons for at least 3