Record Player; Cd Player; Ipod - Denon AVP-A1HDE Owner's Manual

Record Player

Turntable (MM cartridge)
L R
• When connecting a record player with an MC cartridge, use a
commercially available MC head amplifier or a step-up transformer.
• Induction humming (a booming sound) may be produced from the
speakers if the volume is raised with no record player connected.
• With some record players, noise may be generated when the ground
wire is connected. If so, disconnect the ground wire.
NOTE
The AVP-A1HD's SIGNAL GND terminal is meant to reduce noise when
a record player is connected. This is not a safety ground terminal.


CD Player

Connect the cables to be used.
CD player
L R
L R
• When using an optical cable or a BNC cable for the digital audio
connection, make the settings at GUI menu "Source Select" – "CD"
– "Assign" – "Digital" (vpage 46).
• The default analog audio input setting is "RCA" . When using a balanced
cable for the analog audio connection, make the settings at GUI menu
"Source Select" – "CD" – "Assign" – "Analog" (vpage 46).
NOTE
The default AVP-A1HD balance model XLR input connectors pin
alignment is as shown.
q : GROUND
w : HOT
e : COLD

iPod

®
Use a DENON Control Dock for iPod (ASD-1R, sold separately) to
connect the iPod to the AVP-A1HD. For instructions on the Control
Dock for iPod settings, refer to the Control Dock for iPod's operating
instructions.
Example :
iPod
R
L
R
L
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• To assign the iPod to a connector other than VCR (iPod), make the
settings at GUI menu "Source Select" – "(input source to which iPod
dock assigned)" – "Assign" – "iPod dock" (vpage 46).