What To Do If - AEG B47410-5 User Manual

24

What to do if...

2. Pull the door trim to the front to remove
it.
3. Hold the door glass panels on their top edge one by one and pull them upwards out
of the guide
4. Clean the door glass panels.
To install panels follow the procedure in reverse. Insert the smaller panel first, then
the larger.
WHAT TO DO IF...
WARNING!
Refer to "Safety information" chapter.
Problem
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven lamp does not operate The oven lamp is defective
The pyrolysis function does
not operate (the time display
shows "C1")
The time display shows "F2"
The time display shows "F2"
The time display shows an er-
ror code which is not in the list
Possible cause
The oven is not switched on
The clock is not set
The necessary settings are not
set
The fuse in the fuse box is re-
leased
Shelf support rails/oven shelf
runners are not removed
Door is not closed correctly
The door lock is defective
Electronic error
Remedy
Switch on the oven
Set the clock
Control the settings
Control the fuse. If the fuse is
released more than one time,
refer to a qualified electrician.
Replace the oven lamp
Remove shelf support rails /
oven shelf runners
Close the door correctly
Switch the appliance off and
on again through the fuse or
the safety switch in the fuse
box. If the display shows the er-
ror message again, refer to the
Service Force Centre
Switch the appliance off and
on again through the fuse or
the safety switch in the fuse
box. If the display shows the er-
ror message again, refer to the
Service Force Centre