Service Cycle; Display Diagnostic Codes; Diagnostic Codes - Maytag Neptune TL FAV6800A Service

Troubleshooting Procedures
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing
requires power.

Service Cycle

This will be a quick check of all systems.
1. Lid locks.
2. Press Start\Pause.
3. Lid unlocks.
4. Open lid.
5. Close lid.
6. Press Start\Pause.
7. Lid locks.
8. Cold water bleach fill.
9. Bleach fill. Advance to next step if water is not
connected to machine.
10. Tumble using 48 rpm tumble for 10 seconds.
11. Hot fill.
12. Fabric softener fill. Advance to next step if water is
not connected to machine.
13. Drain.
14. Spin to 150 rpm.
15. Spin to 350 rpm.
16. Spin to 850 rpm.
17. Pump cycles on and off.
18. Coast to 0 rpm.
19. Lid unlocks.
If a failure occurs during the test, an error screen will
appear. Select OK to continue. The test will continue
depending on the nature of the failure.

Display Diagnostic Codes

Enter Service Mode to display diagnostic codes.
Diagnostic codes will be shown in the right pane as
shown.
©2003 Maytag Appliances Company
!
WARNING
Access Other Features
To view details about the software version and the total
cycle count, select the diagnostic code portion of the
screen. You will also be able to view details about the
number of cycles since a diagnostic code occurred, if a
code is logged.

Diagnostic Codes

Diag. Description
Code
1 No Drain
The lid fails
2
to unlock
3 No Fill
The lid fails
4
to lock
16022808 Rev. 0
Trigger Action to be
taken
The water
Go to "Will Not
level fails to
Drain"
drop below
Troubleshooting
the Low level
Section
before a spin
Lid failed to Go to "Will Not
unlock after Unlock"
multiple Troubleshooting
attempts
Section
Go to "No Water
Total fill 14
Fill"
minutes
Troubleshooting
exceeded.
Section
Go to "Will not
Lid failed to
unlock"
lock after 11
Troubleshooting
attempts
Section
25