Steering Head Inspection - Yamaha Fazer Service Manual

Â
¿ À
Ã

STEERING HEAD INSPECTION

STEERING HEAD INSPECTION
WARNING
Securely support the Motorcycle so that
there is no danger of it falling over.
1. Stand the Motorcycle on a level surface.
NOTE :
Stand the Motorcycle on its Center Stand.
2. Elevate the Front wheel by placing a suit-
able stand under the Engine.
3. Check:
• Handlebar assembly
• Steering assembly bearings
4.
5.
• Bands ¿
• Bolts (Handlebar Upper holders) À - 4 Nos.
• Handlebar upper holders Á - 2 Nos.
¿
Á
• Handlebar Â
Ä
• Handle crown bolts Ã
• Handle crown Ä
5. Adjust :
• Steering head
ææææææææææææææææææææææææææææææææææ
Adjustment steps:
• Remove the lock washer ¿
• Remove the Ring Nut À (upper) and Dumper
Rubber Á , then loosen the Ring Nut  (lower)
using the Ring Nut wrench.
• Tighten the ring nut (lower) at initial tighten-
ing torque
• Loosen the ring nut  (lower) 1/4 turn.
• Tighten the Ring Nut (lower) using the Ring Nut
Wrench up to final tightening torque.
3-22
INSP
ADJ
Grasp the Handle Bar and gently rock the
Steering.
Looseness Ÿ Adjust the Handlebar.
Grasp the bottom of the lower Front Fork
tubes and gently rock the Fork Assembly.
Looseness Ÿ Adjust the Steering Head.
Loosen - Pinch Bolt - (Handle Crown)
Remove :
Ring nut wrench :
YSST 621
Ring nut-lower (initial tightening ):
33 Nm (3.3 m.kg, 25 ft.lb)