Yamaha Fazer Service Manual page 123

ENGINE ASSEMBLY AND ADJUSTMENTS
¿
New
À
Ä
Ã
Á
Â
¿
CLUTCH INSTALLATION
1. Install :
• Oil Seal ¿
• Circlip
• Push Lever Axle À
NOTE :
Install longer side ç of the Spring on Push Le-
ver and smaller side è on the Crankcase Notch.
2. Install :
• Spacer ¿
À
• Primary Driven Gear À
• Thrust Washer Á
• Clutch Boss Â
• Lock Washer Ã
¿
• Clutch Boss Nut Ä
3. Tighten :
• Nut Clutch Boss ¿ while holding the Clutch
À
4. Bend :
• Lock Washer tab
(along a flat side of the end)
5. Install :
• Friction Plate ¿ 5 Nos
• Clutch Plate À 4 nos
NOTE :
• Install the Clutch Plates and Friction Plates al-
ternately on the Clutch Boss, starting with a
Friction Plate and ending with a Friction Plate.
• Lubricate all Clutch and Friction Plates with
Engine Oil before installation
• Be sure to install a Clutch Plate with "Projec-
tion Mark" offset approximately 90 º from pre-
vious plates projection continue this procedure
in clockwise direction until all Clutch Plates
are installed
4-49
ENG
New
New
New
Boss with Clutch Hub Holder À
Clutch Hub Holder
YSST - 233
Nut (Clutch Boss ):
60 Nm (6.0 m. kg, 43.5 ft. lb)