Electrolux EOB53203 User Manual page 32

32 electrolux
• To clean metal surfaces use a usual
cleaning agent
• Clean the oven interior after each use.
Thus you can remove dirt more easily
and it does not burn on.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all oven accessories (with a soft
cloth with warm water and cleaning
agent) after each use and let them dry.
• If you have nonstick accessories, do not
clean them using an aggressive agents,
sharp edged objects or dishwasher. It
can destroy nonstick coating!
Cleaning the door gasket
• Regularly do a check of the door gasket.
The door gasket is around the frame of
the oven cavity. Do not use the appliance
if the door gasket is damaged. Contact
the Service Centre.
• To clean the door gasket refer to the
general information about the cleaning.
Catalytic panels
The catalytic panels are self-cleaning. The
catalytic panels absorb fat which collects
when the appliance operates.
To support the self-cleaning process re-
move the accessories from the appliance
and run an empty oven at maximum tem-
perature for approximately one hour.
• Discolouration of the catalytic sur-
face has no effect on the catalytic
properties.
• To prevent damage to the catalytic
surface, do not to clean the catalytic
panels with oven sprays, abrasive
cleaners, soap or other cleaning
agents.
Oven lamp
Warning! Be careful! There is the risk
of electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the oven
for protection of the oven light and
glass cover.
1. Turn the glass cover anti-clockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with appli-
cable 300°C heat-resistant oven light
bulb.
Use the same oven lamp type.
4. Install the glass cover.
Removable shelf runners and catalytic
panels
To clean the oven cavity remove the shelf
runners and catalytic panels.
Caution! Be careful when you remove
the shelf runners. The catalytic panels
are not attached to the oven cavity and
can fall out when you remove the shelf
runners.
Removing the side rails
1. Pull the front of the shelf support rail
away from the side wall.
Hold the rear shelf runners and catalytic
panel in place with the other hand.
2. Pull the shelf runners from the back of
the side wall to remove the shelf sup-
port rails.
1
2