Carriage Return - HP Wireless Barcode Scanner User Manual

Carriage Return

Scan the following bar code to set the scanner back to the factory defaults.
Figure 1-4
NOTE: Scanning the "Set All Defaults" bar code does not change the interface type.
If a carriage return is required after each scanned bar code, scan the following bar codes in order:
Figure 1-5
Figure 1-6
Figure 1-7
Figure 1-8
Figure 1-9
2 Chapter 1 Quick Setup
Set All Defaults
Enter Programming Mode
Set Global Suffix
0
D
Exit Global Suffix Mode