European Union Regulatory Notice; Mexico Notice; Laser Compliance - HP Wireless Barcode Scanner User Manual

European Union Regulatory Notice

Products bearing the CE marking comply with one or more of the following EU Directives as may be
applicable:
Low Voltage Directive 2006/95/EC; EMC Directive 2004/108/EC; Ecodesign Directive 2009/125/EC;
R&TTE Directive 1999/5/EC; RoHS Directive 2011/65/EU
Compliance with these directives is assessed using applicable European Harmonised Standards.
The full Declaration of Conformity can be found at the following web site:
(Search with the product model name or its Regulatory Model Number (RMN), which may be found
on the regulatory label.)
The point of contact for regulatory matters is: Hewlett-Packard GmbH, Dept./MS: HQ-TRE,
Herrenberger Strasse 140, 71034 Boeblingen, GERMANY.

Mexico Notice

Declaración para México
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible que este
equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar
cualquier interferencia, incluyendo la que pueda causar su operación no deseada.
Radio Model: DLBTMCX
Frequency: 2400 to 2483.5 MHz

Laser Compliance

This device is classified as a Class 2 Laser Product in accordance with US FDA regulations and the
IEC 60825-1.
Each laser product complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to
Laser Notice No. 50, dated June 24, 2007; and with IEC 60825-1:2007
CAUTION:
Output Radiation 1mW Avg. Emitted Wave Length 650nm
WARNING!
herein or in the laser product's installation guide may result in hazardous radiation exposure. To
reduce the risk of exposure to hazardous radiation:
• Do not try to open the module enclosure. There are no user-serviceable components inside.
• Do not operate controls, make adjustments, or perform procedures to the laser device other than
those specified herein.
• Allow only HP Authorized Service technicians to repair the unit.
34 Appendix C Agency Regulatory Notices
CLASS 2 LASER RADIATION DO NOT STARE INTO THE BEAM
Use of controls or adjustments or performance of procedures other than those specified
http://www.hp.eu/certificates