Table of Contents
Advertisement
Figure 4-12
A red beam illuminates the label. The field of view indicated by the aiming system will be smaller
when the scanner is closer to the bar code and larger when it is farther from the code. Symbologies
with smaller bars or elements (mil size) should be read closer to the unit. Symbologies with larger
bars or elements (mil size) should be read farther from the unit.
If the aiming system is centered and the entire bar code is within the aiming field, you will get a good
read. Successful reading is signaled by an audible tone plus a good-read green spot LED indicator.
Refer to the HP Wireless Barcode Scanner Programming Reference Guide (PRG) for more
information about this feature and other programmable settings.
Linking the Reader
Link RF Devices to Base
For RF devices, before configuring the interface it is necessary to link the handheld with the base.
To link the handheld and the base, either press the trigger to wake it, or simply mount into the base to
wake up for operation. If the reader was previously linked to another base, you must first scan the
Unlink bar code before re-linking to the new base.
Figure 4-13
Link Scanner to Bluetooth Adapter
1.
Install any drivers provided with the Bluetooth adapter.
2.
Scan the Enable RF Link to Server label below to make the scanner visible to the host computer.
3.
Use the host computer's Bluetooth manager to "Discover new devices" and select "HP Wireless
Bluetooth Scanner." If you receive an error message, it may be necessary to disable security on
the device.
4.
Use an RS-232 terminal program to see incoming data on the port designated by the computer's
Bluetooth manager.
Figure 4-14
NOTE:
The scanner can be set up to require a PIN code when connecting. If you want to set up a
PIN, or when adding new equipment to a system that uses a custom security PIN, please see the HP
Wireless Barcode Scanner Programming Reference Guide (PRG) for information.
18
Chapter 4 Setting Up and Using the Scanner
Relative Size and Location of Aiming System Pattern
Unlink
Enable RF Link to Server
Hide quick links:
Advertisement
Table of Contents
