Table of Contents
Advertisement
Rear Panel
Power port (9V)
Switching Hub
(10/100BaseT)
WAN port
(10BaseT)
Reset Button
DIP switches
Printer Port
Figure 2: Rear Panel
Connect the supplied power adapter here.
Use standard LAN cables (RJ45 connectors) to connect this port to
your PCs. Both 10BaseT and 100BaseT connections can be used
simultaneously.
Use the "Uplink" port ONLY to connect to a normal port
on another hub.
Connect the ADSL or Cable Modem here. If your modem came
with a cable, use the supplied cable. Otherwise, use a standard LAN
cable.
When pressed and released, the Broadband Router will reboot
(restart).
This button can also be used to clear ALL data and restore ALL
settings to the factory default values.
To restore the factory default values:
•
Power Off
•
Hold the Reset Button down while you Power On.
•
Continue holding the Reset Button until the Status (Red) LED
blinks TWICE.
•
Release the Reset Button.
The factory default configuration has now been restored, and
the Broadband Router is ready for use.
Refer to the following table.
Standard parallel printer port. If you wish to share a printer, connect
it here.
Introduction
5
Advertisement
Table of Contents
