Rear Panel - Planet VRT-401 User Manual

Rear Panel

DMZ
Reset Button
WAN port
(10/100BaseT)
10/100BaseT
LAN connec-
tions
Power port
Figure 3: Rear Panel
Use a standard LAN cable to connect a normal port on the
other hub.
This button has two (2) functions:
Reboot. When pressed and released, VRT-401 will reboot
(restart).
Clear All Data. This button can also be used to clear ALL
data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the
RED LED has flashed TWICE.
4. Release the Reset Button. VRT-401 is now using the
factory default values.
Connect the DSL or Cable Modem here. If your modem came
with a cable, use the supplied cable. Otherwise, use a standard
LAN cable.
Use standard LAN cables (RJ45 connectors) to connect your
PCs to these ports.
Note:
Any LAN port on VRT-401 will automatically function as an
"Uplink" port when required. Just connect any port to a normal
port on the other hub, using a standard LAN cable.
Connect the supplied power adapter here.
Introduction
5