Table of Contents
Advertisement
Broadband Router User Guide
LAN Screen
Use the LAN link on the main menu to reach the LAN screen An example screen is shown
below.
Data - LAN Screen
TCP/IP
IP Address
IP address for the Broadband Router, as seen from the local LAN. Use
the default value unless the address is already in use or your LAN is
using a different IP address range. In the latter case, enter an unused IP
Address from within the range used by your LAN.
Subnet Mask
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the Broadband Router is attached (the same value as
the PCs on that LAN segment).
•
DHCP Server
•
•
See the following section for further details on using DHCP.
Buttons
Save the data on screen.
Save
Cancel
The "Cancel" button will discard any data you have entered and reload
the file from the Broadband Router.
Figure 5: LAN Screen
If Enabled, the Broadband Router will allocate IP Addresses to
PCs (DHCP clients) on your LAN when they start up. The default
(and recommended) value is Enabled.
If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-configured to
treat the Broadband Router as the Gateway. See the following
section for further details.
The Start IP Address and Finish IP Address fields set the values
used by the DHCP server when allocating IP Addresses to DHCP
clients. This range also determines the number of DHCP clients
supported.
14
Advertisement
Table of Contents
