Cleaning The Ceramic Hob - AEG 1010V-W Instruction Book

Electric cooker
Table of Contents

Advertisement

Cleaning the ceramic hob

Use the scraper supplied to remove spillages immedi-
ately, while the hob is still hot, especially sugar and
foods with a high sugar content (e.g. jam), melted plas-
tics and foil, all of which can damage the hob if left.
IF THE HOB IS VERY SOILED
1 Remove soilage using the razor blade scraper (see
below).
2 Use a hob cleaner product when the hot-hob warning
lights have all gone out. Shake the bottle and apply a
small quantity of cleaner directly onto the hob. Rub
clean using a damp cloth or paper towels.
3 Use a damp cloth to remove all remaining traces of the
cleaner, which could otherwise burn on when the hob is
next used. Wipe the hob dry.
Razor blade scraper
T
HE RAZOR BLADE SCRAPER SHOULD BE KEPT WELL OUT
OF THE REACH OF CHILDREN
scraper carefully, as the razor blade is extremely sharp.
Use the scraper to remove spillages from the ceramic
hob.
HOW TO USE THE RAZOR BLADE SCRAPER
1 Pull back the protective cover until the blade is visi-
ble (
SEE ILLUSTRATION
2 Make sure that the razor blade is clean and not
worn. There is a risk, otherwise, that it might
damage the hob. New razor blades can be bought
from drugstores.
3 Angle the scraper at approx. 45° and scrap away
the spillage. The razor blade can be pressed
down hard onto the hob without causing any
damage.
4 Carefully clean the blade by wiping it with
kitchen roll paper.
5 When you have finished, press the protective
cover forwards as far as it will go. Keep the
scraper out of the reach of children.
CHANGING THE RAZOR BLADE
1 Open the scraper by completely unscrewing the screw
(no screwdriver needed) and then place the new razor
blade at the front edge.
2 Put the scraper together again and screw the
screw back into place.
3 Press the protective cover forwards as far as it
will go to cover the razor -blade.
:
. Use the razor blade
:
).
:
The ceramic hob
11

Advertisement

Table of Contents
loading

Table of Contents