Electrolux 1000FA User Manual page 12

12
External cleaning
We recommend that non-abrasive cleaners are used; Avoid the use of metal objects, steel
wool or nylon pads, abrasive or caustic products, as these may scratch the surface. Regularly
wipe over the control panel, oven door and door seal using a soft cloth well wrung out in
warm water to which a little washing up liquid has been added.
Cleaning the hotplates
Remove spillages as soon as possible, to prevent them from burning onto the hotplate
Spills onto the actual plate should be removed using warm water and a soft brush, nylon or
plastic scorer. To keep the plates looking as new, hotplate conditioner can be purchased
from most hardware stores, e.g. "4 Hob" by HomeCare Products (follow the manufacturer's
instruction for use). Alternatively, wipe the plates with a drop of olive oil on a kitchen towel
to avoid rust. It is important to note that the plate will smoke a little and produce a slightly
unpleasant odour when next used.
Drying
Important: After cleaning, dry the hotplates thoroughly by switching on to a low-medium
setting for a few minutes.
Restoring
To maintain the appearance of your sealed hotplates apply a little salt-free vegetable oil or
restorative agent periodically.
To apply vegetable oil: first heat the hotplate on a medium setting for 30 seconds then turn off.
Pour a very small amount of salt-free oil onto a dry cloth or kitchen paper. Apply a thin coat of
oil to the hotplate surface and wipe off any excess. Heat the hotplate on a medium setting for 1
minute.
To apply restorative agent: first heat the hotplate on a medium setting for 30 seconds then
turn off. Apply a very thin coating of Collo Electrol (using the applicator). Heat a hotplate
on a high setting for 2-3 minutes to cure. Some smoke will occur, this is normal and
nontoxic. (NB: this product is a restorative agent not a cleanser. It is available from
hardware stores).
Stainless steel parts: the stainless steel spill rings may become straw coloured with use. Use
a proprietary stainless steel cleaner to remove this straw discolouration. This also applies to
the area around the hotplates on stainless steel hobs.
Oven Cavity
The enameled oven cavity is best cleaned whilst the oven is still warm.
Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time
to time it will be necessary to do a more thorough cleaning, using a proprietary oven
cleaner.
Lid
This should be cleaned with a soft cloth soaked in warm detergent water. Do not use
abrasive scourers or steel wool.
Oven Shelves and shelf support
To clean the oven shelves and shelf support soak in warm soapy water and remove stubborn
marks with a well-wetted soap impregnated pad. Rinse well and dry with a soft cloth.
.