Electrical Connection - Electrolux 1000FA User Manual

The minimum distance combustible material can be fitted above the cooker in line with the
edges of the cooker is 69 cm.
Levelling
The appliance is provided with adjustable small feet placed in
the back and front corners of the base.
By adjusting the small feet it is possible to change the height
of the appliance so as to ensure a better leveling with other
surfaces and an even distribution of the liquids contained in
pots and pans.
Electrical connections
Any electrical work required to install this hob and the supply cable should be carried out by a
qualified electrician or competent person, in accordance with the current regulations.
This appliance must be earthed.
The manufacturer disclaims any responsibility should these safety instructions not be carried out.
This cooker is designed to be connected to a 230/400V, 50Hz electrical supply.
To connect to the electricity supply, use cable type H05 RR-F.
Before switching on, make sure the electricity supply voltage is the same as that indicated on
the rating plate.
The cooker is supplied without supply cable. A flexible supply cable must be fitted, in accordance
with the specification gave in the relevant table no. 1.
In case of a direct connection to the mains you have to interpose an omnipolar switch with a
minimum opening between contacts of 3 mm must be done under over voltage category III
condition.
The switch should be sited within 2m of the hob and be easily accessible upon completion of the
installation.
The yellow-green grounding cable has not to be interrupted by the switch.
NOTE: The earth wire should be about 2 cm longer than the live and neutral wires.
If the power supply cable is damaged, it must be replaced by
the manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
After installation and connecting, the cable must be placed so
that it cannot at any point reach a temperature of more than
50°C above the ambient temperature.
17
Power
supply
cable