Table of Contents
Advertisement
Time Format
12 hour AM/PM
Units
ºF and PPM
Reset Config. to
Default
Press +
Are you sure?
+ to proceed
Config. reset
Confirmed
Use this function to erase all previous system configuration and reset all configuration parameters back to
the factory default values. This function is NOT reversible--be careful.
Maintenance Menu
The Maintenance Menu will be displayed only if the optional AQL-CHEM is used and the Sensing System is enabled
in the Chemistry Config. Wizard. This menu is used to perform functions relating to the AQL-CHEM ORP and pH
sensing kit.
pH Calibration
Wizard, + to enter
Use this Wizard to calibrate the AQL-CHEM's pH probe. This requires a manual pH test of the pool water
using a dependable red phenol test kit.
Clean Probe Wizard
+ to enter
Use this Wizard to clean the AQL-CHEM's ORP and pH probes. The probes must be clean and free from oil,
chemical deposits and contamination to function properly. Slow response, increased need to calibrate,
and inconsistent readings are indications that the probes need to be cleaned.
Toggle between 12 hour AM/PM (default) and 24 hour time format options
Move to previous/next configuration menu
Toggle between ºF and PPM (default) and ºC and g/L (Metric) options
Move to previous/next configuration menu
Initiate reset of all configuration parameters
Move to previous/next configuration menu (config. not reset)
Reset all configuration parameters
Move to previous/next menu (config. not reset)
Move to previous/next configuration menu
(only displays if Sensing System is enabled)
Push to access pH Calibration Wizard
Move to previous/next menu item
Push to access Clean Probe Wizard
Move to previous/next menu item
29
Hide quick links:
Advertisement
Table of Contents
