Changing Door Stop - Electrolux LAVATHERM 56740 User Manual

32 Installation
Connect the machine to an earthed socket, in accordance with current wiring
regulations.
WARNING!
The manufacturer declines any responsibility for damage or injury through
failure to comply with the above safety precautions. Should the appliance
power supply cable need to be replaced, this must be carried out by our
Service Center.
WARNING!
The power supply cable must be accessible after installing the machine.

Changing door stop

WARNING!
The door stop may only be changed by a specialist. If necessary, please contact our
after-sales service or your specialist dealer.
WARNING!
Before changing the door stop, disconnect the mains plug.
1. Open loading door.
Unscrew hinge A from the front of the
2.
machine and take off the loading door.
Remove cover plates B and C. To do this,
3.
insert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block D from
the snap-on fixture, take out and re-in-
sert on the other side having rotated the
block through 180°.
Unscrew hinge A from the loading door,
5.
rotate through 180°, re-insert on the
opposite side and screw down.
A
B
A
C
D
C