Something Not Working - Electrolux EDC 77150 W User Manual

125983630 gb.qxp 2006-10-02
20 electrolux something not working

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to
indicate that the machine is not working.
Once the problem has been eliminated, press the Start/Pause
the programme. If after all checks, the problem persists, contact your local Service
Centre.
Malfunction
Dryer does not work.
Drying results
unsatisfactory.
Loading door does not
close.
12:39 Page 20
Possible cause
Mains plug is not plugged in
or fuse is not working
correctly.
Loading door is open.
Have you pressed the
button?
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged with lint.
Incorrect volume of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at
installation site differs from
standard setting of machine.
Fine strainer not in place
and/or large mesh filter not
locked in place.
button to restart
Solution
Plug in at mains socket.
Check fuse in fuse box
(domestic installation).
Close loading door.
Press the button again.
Select a different programme the
next time you dry (see "Overview
of programmes" section).
Clean lint filter.
Clean heat exchanger.
Observe recommended
loading volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum
and drum ribs
Re-programme standard setting
for degree of drying (see
'Programming options' section).
Install fine strainer and/or
snap large mesh filter into
place.