Programme Information - Electrolux EDC 77150 W User Manual

125983630 gb.qxp 2006-10-02
16 electrolux programme information

Programme information

Objective
Adjusting the level
of conductivity
O = Cancelling/OFF
12:39 Page 16
Implementation
Water contains, a variable quantity of limestone and mineral salts
of which quantities vary according to geographical locations thus
varying its conductivity values.
Relevant variations of the conductivity of the water compared to
those prefixed by the factory could slightly influence the residual
humidity of the laundry at the end of the cycle. Your dryer allows
you to regulate the sensitivity of the drying sensor based on
conductivity values of the water by using the following procedure.
T T o o a a c c c c e e s s s s a a d d j j u u s s t t m m e e n n t t m m o o d d e e : :
1. Turn the programme selector dial to switch on the appliance.
2. In selection mode,press simultaneously the buttons
D D r r y y n n e e s s s s and S S t t a a r r t t / / P P a a u u s s a a .
Press the buttons down until until «C0» appears on the digits.
A A d d j j u u s s t t i i n n g g t t h h e e l l e e v v e e l l o o f f c c o o n n d d u u c c t t i i v v i i t t y y :
Press the S S t t a a r r t t / / P P a a u u s s a a button sequentially: the level of
conductivity is indicated by the lighting of the horizontal
hyphens.
Display Conductivity
C C O O
Low
C C O O
Medium
C C O O High
Normally, the appliance is factory-set to the highest level;
however, certain models may be configured differently.
M M e e m m o o r r i i z z i i n n g g t t h h e e n n e e w w s s e e t t t t i i n n g g : :
Simultaneously press the buttons D D r r y y n n e e s s s s and S S t t a a r r t t / / P P a a u u s s a a .
Press the buttons down until the previous drying cycle time
appears again on the display and the buzzer sounds.
To reset a programme and to switch off the machine turn
the selector dial to O. Now can a new programme be
selected.
Approximate value µS/cm
< 300
300-600
>600