Electrolux EDC 77150 W User Manual page 11

125983630 gb.qxp 2006-10-02
" " C C o o o o l l i i n n g g " "
This symbol appears on the dispay that
the appliance is in the cooling phase.
At the end of drying, there is a 10 minute
cooling phase to cool the laundry.
" " L L o o n n g g A A n n t t i i c c r r e e a a s s e e " "
This symbol appears on the dispay at
the end of the cooling phase, during
the anti-creasing phase and at the end
of the programme.
I I n n d d i i c c a a t t o o r r l l i i g g h h t t s s
These lights indicate the following functions:
" " W W a a t t e e r r r r e e s s e e r r v v o o i i r r f f u u l l l l " " l l i i g g h h t t
This light comes on at the end of the
programme to remind you that the water
reservoir must be emptied out. If this light
illuminates during a programme this means
that the water reservoir is full. The buzzer
sounds, the programme stops, the light of
the Start/Pause button flashes.
" " F F i i l l t t e e r r c c l l e e a a n n i i n n g g " " l l i i g g h h t t
It comes on every 80 cycles to remind you
that the condenser must be cleaned.
" " C C o o n n d d e e n n s s e e r r c c l l e e a a n n i i n n g g " " l l i i g g h h t t
This light illuminates at the end of the
programme to remind you that the
filters must be cleaned.
At the end of the programme
All drying programmes end with a 10
minute cooling phase.
You may remove the laundry after this
phase. The lights
minate.
The display shows a static zero.
If the laundry is not removed at the end
of the cycle, the dryer performs an a a n n t t i i - -
c c r r e e a a s s i i n n g g phase (duration: 30 minutes
maximum). If you do not remove the
laundry, the dryer will stop automatically
at the end of the anti-creasing phase.
Lights and remain lit and the
12:39 Page 11
buzzer sounds for 2 minutes.
If you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
Turn the programme selector dial to " " O O " "
to switch the machine off. Remove the
laundry from the drum and carefully
check that the drum is empty. The appli-
ance is switched off.
Remove the laundry.
I I f f y y o o u u o o p p e e n n a a n n d d t t h h e e n n c c l l o o s s e e t t h h e e d d o o o o r r b b e e f f o o r r e e
t t u u r r n n i i n n g g t t h h e e s s e e l l e e c c t t o o r r d d i i a a l l t t o o " " O O " " a a l l l l t t h h e e l l i i g g h h t t s s
c c o o r r r r e e s s p p o o n n d d i i n n g g t t o o t t h h e e p p h h a a s s e e s s m m a a k k i i n n g g u u p p
t t h h e e p p e e r r f f o o r r m m e e d d p p r r o o g g r r a a m m m m e e c c o o m m e e o o n n . .
A A f f t t e e r r e e a a c c h h u u s s e e
• Clean the filters.
• Empty the water reservoir.
Important!
If the drying programme has to be
stopped before it reaches the end, we
recommend that you turn the pro-
gramme selector dial to position Cooling
phase before removing the laundry. This
will avoid a build-up of heat inside the
appliance.To do this first turn the dial to
"O O f f f f " and then to Cooling
depress Start button.
M M o o d d i i f f y y i i n n g g t t h h e e p p r r o o g g r r a a m m m m e e
To change a programme which is run-
ning, first cancel it by turning the pro-
gramme selector dial to "O O ". Select the
new programme and press the Start
and , and illu-
button .
use electrolux 11
and wait until the end of this cooling
and
GB