Table of Contents
Advertisement
125992691.qxd
26/05/2004
11:13
Something Not Working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without
calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
IMPORTANT: if the END light flashes, the buzzer sounds and an alarm code is displayed, switch the machine
off and call the Service Centre.
Symptom
The tumble dryer does not
start
Drying takes too long or
laundry is not dry enough.
The drum light does not
light up:
If after the above checks, there is still a fault, call your local Service Force Centre.
Pagina
13
Possible causes
The door(s) has (have) not been closed.
●
The plug is not properly inserted in the power socket.
●
There is no current at the socket.
●
The main fuse or the fuse in the plug has blown.
●
The selector dial is not set correctly.
●
he water reservoir is full or not properly inserted (the FULL TANK light is on).
T
●
The programme starts in any case but it stops after approx. 4 minutes.
The START/PAUSE Button has not been depressed.
●
The DELAY START option has not been selected.
●
The laundry has not been spun properly.
●
The filters and/or the condenser are clogged up.
●
The water reservoir is full.
●
The room temperature is too high.
●
The selected time or drying cycle was not suitable for the laundry.
●
The LOW TEMPERATURE button has been pressed.
●
There is too much laundry inside the appliance.
●
The dryer is not correctly installed.
●
The Programme/Time selector dial is on position "RESET/OFF".
●
The lamp is defective.
●
13
Advertisement
Table of Contents
