Something Not Working - Electrolux EDC 5349 Instruction Booklet

Table of Contents

Advertisement

125980820 gb.qxp
2005-01-04

Something Not Working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Centre, please carry out the
checks listed below.
During machine operation it is possible that one of the following messages appears on the display:
IMPORTANT: if the «Warning» message and an alarm code (e.g. E21) appear on the display and the
Symptom
The tumble dryer does not
start
Drying takes too long or
laundry is not dry enough.
If after the above checks, there is still a fault, call your local Service Force Centre.
12:59
Page 20
Possible causes
The door(s) has (have) not been closed («Can't lock door»).
The plug is not properly inserted in the power socket.
There is no current at the socket.
The main fuse or the fuse in the plug has blown.
The selector dial is not set correctly.
he water reservoir is full or not properly inserted («The tank is full,
T
please empty»). The programme starts in any case but it stops after
approx. 4 minutes.
The START/PAUZE Button has not been pressed.
The DELAY START option has been selected.
The laundry has not been spun properly.
The filters and/or the condenser are clogged up («Please clean
filters/condenser»).
The water reservoir is full («The tank is full, please empty»).
The room temperature is too high.
The selected time or drying cycle was not suitable for the laundry.
The HALF POWER
The HALF LOAD
There is too much laundry inside the appliance.
The dryer is not correctly installed.
option has been selected.
option has been selected.
20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents