Table of Contents
Advertisement
18 electrolux programme information
Programme information
Objective
Adjusting the level
of conductivity
RESET =
Cancelling/OFF
Water contains, a variable quantity of limestone and mineral salts
of which quantities vary according to geographical locations thus
varying its conductivity values.
Relevant variations of the conductivity of the water compared to
those prefixed by the factory could slightly influence the residual
humidity of the laundry at the end of the cycle. Your dryer allows
you to regulate the sensitivity of the drying sensor based on
conductivity values of the water by using the following procedure.
T T o o a a c c c c e e s s s s a a d d j j u u s s t t m m e e n n t t m m o o d d e e : :
1. Turn the programme selector dial to switch on the appliance.
2. In selection mode,press simultaneously the buttons
K K u u r r z z / / Q Q u u i i c c k k and S S t t a a r r t t / / p p a a u u s s e e
Press the buttons down until until «C0» appears on the digits.
A A d d j j u u s s t t i i n n g g t t h h e e l l e e v v e e l l o o f f c c o o n n d d u u c c t t i i v v i i t t y y :
Press the Z Z e e i i t t w w o o r r w w a a h h l l / / D D e e l l a a y y button sequentially: the level
of conductivity is indicated by the lighting of the horizontal
hyphens.
Display
Conductivity
CO
Low
CO
Medium
CO
High
Normally, the appliance is factory-set to the highest level;
however, certain models may be configured differently.
M M e e m m o o r r i i z z i i n n g g t t h h e e n n e e w w s s e e t t t t i i n n g g : :
Simultaneously press the buttons K K u u r r z z / / Q Q u u i i c c k k and
.
S S t t a a r r t t / / p p a a u u s s e e
Press the buttons down until the previous
drying cycle time appears again on the display and the
buzzer sounds.
To reset a programme and to switch off the machine turn
the selector dial to RESET. Now can a new programme be
selected.
Implementation
Approximate value µS/cm
< 300
300-600
>600
Advertisement
Table of Contents
