Table of Contents
Advertisement
Programme information
Objective
Adjusting the level
of conductivity
O = Cancelling/OFF
Water contains, a variable quantity of limestone and mineral salts
of which quantities vary according to geographical locations thus
varying its conductivity values. Relevant variations of the
conductivity of the water compared to those prefixed by the
factory could slightly influence the residual humidity of the laundry
at the end of the cycle. Your dryer allows you to regulate the
sensitivity of the drying sensor based on conductivity values of the
water by using the following procedure.
T T o o a a c c c c e e s s s s a a d d j j u u s s t t m m e e n n t t m m o o d d e e : :
1. Turn the programme selector dial to switch on the appliance.
2. In selection mode,press simultaneously the buttons
DRYNESS and START.
Press the buttons down until the pilot lights above each ones
begin to flash and one of the pilot lights indicating the drying
phase lights
,
A A d d j j u u s s t t i i n n g g t t h h e e l l e e v v e e l l o o f f c c o o n n d d u u c c t t i i v v i i t t y y :
Press the START/PAUSE button sequentially: the level of
conductivity is indicated by the phase pilot lights, which light
in various combinations as follows:
LED lit
Conductivity
Low
Medium
High
Normally, the appliance is factory-set to the highest level;
however, certain models may be configured differently.
M M e e m m o o r r i i z z i i n n g g t t h h e e n n e e w w s s e e t t t t i i n n g g : :
Simultaneously press the buttons DRYNESS and START.
Press the buttons down until the pilot lights above each
ones stop flashing and the buzzer sounds.
To reset a programme and to switch off the machine turn
the selector dial to O. Now can a new programme be
selected.
programme information electrolux 17
Implementation
and
remains it.
Approximate value µS/cm
< 300
300-600
>600
Advertisement
Table of Contents
