Programme Information - Electrolux EDC 77570 W User Manual

125987340.qxp 2007-03-16

Programme information

Objective
Adjusting the level
of conductivity
O = Cancelling/OFF To reset a programme and to switch off the machine turn
11:42 Page 17
Implementation
Water contains, a variable quantity of limestone and mineral
salts of which quantities vary according to geographical
locations thus varying its conductivity values. Relevant
variations of the conductivity of the water compared to those
prefixed by the factory could slightly influence the residual
humidity of the laundry at the end of the cycle. Your dryer
allows you to regulate the sensitivity of the drying sensor
based on conductivity values of the water by using the
following procedure.
To access adjustment mode:
1. Turn the programme selector dial to switch on the
appliance.
2. In selection mode,press simultaneously the buttons
DRYNESS and START.
Press the buttons down until until «C0» appears on the digits.
Adjusting the level of conductivity: Press the START/PAUSE
button sequentially: the level of conductivity is indicated by
the lighting of the horizontal hyphens.
Normally, the appliance is factory-set to the highest level;
however, certain models may be configured differently.
M M e e m m o o r r i i z z i i n n g g t t h h e e n n e e w w s s e e t t t t i i n n g g : :
Display Conductivity
Low
C C O O
Medium
C C O O
High
C C O O
Simultaneously press the buttons DRYNESS and START.
Press the buttons down until the previous drying cycle time
appears again on the display and the buzzer sounds.
the selector dial to O O . Now a new programme can be
selected.
programme information electrolux 17
Approximate value
uS/cm
<300
300-600
>600
G G B B