PERIODIC MAINTENANCE AND MINOR REPAIR
1. Screw ( 2)
Replacing a turn signal light
bulb
1. Remove the turn signal lens by re-
6
moving the screws.
1. Turn signal light bulb
2. Remove the defective bulb by
EAU03218
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
CAUTION:
_
Do not overtighten the screws, oth-
erwise the lens may break.
_
Supporting the motorcycle
Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motor-
cycle is in a stable and level position
before starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
EC000108
2. Raise the front wheel off the
6-36
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
ground by using a motorcycle
stand.
EAU01579