Rear Wheel - Yamaha Drag Star XVS250 Owner's Manual

Rear wheel

To remove the rear wheel
WARNING
_
It is advisable to have a Yamaha
dealer service the wheel.
Securely support the motor-
cycle so that there is no danger
of it falling over.
_
1. Loosen the axle nut and the brake
torque rod nut at the brake shoe
plate.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU03189
EW000122
1. Axle nut
2. Brake torque rod
3. Brake torque rod nut
4. Brake rod
5. Brake pedal free play adjusting nut
2. Lift the rear wheel off the ground
according to the procedure on
page 6-36.
3. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the nut and the bolt.
4. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod at the brake cam-
shaft lever.
1. Wheel axle
2. Drive chain slack adjusting nut
3. Locknut
5. Loosen the locknut and the drive
6. Remove the axle nut, and then pull
7. Push the wheel forward, and then
NOTE:
_
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
_
8. Remove the wheel.
6-39
chain adjusting nut on both ends
of the swingarm.
the wheel axle out.
remove the drive chain from the
rear sprocket.
6