Yamaha Drag Star XVS250 Owner's Manual page 70

PERIODIC MAINTENANCE AND MINOR REPAIR
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
6
2. Lift the wheel up between the fork
legs.
1. Retainer
EAU03738
NOTE:
_
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
_
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Push down hard on the handlebar
several times to check for proper
fork operation.
6. Tighten the wheel axle to the
7. Install the front wheel axle pinch
8. Connect the speedometer cable.
6-38
specified torque, and then install
the rubber cap.
Tightening torque:
Wheel axle:
59 Nm (5.9 m·kg)
bolt, and then tighten it to the
specified torque.
Tightening torque:
Front wheel axle pinch bolt:
20 Nm (2.0 m·kg)