Residual Heat Function; Error Code - Electrolux EOB 6790 Instruction Booklet

Residual Heat Function

When a Cooking Duration time is set, the heating
elements of the oven will automatically go off a few
minutes before the end of the programmed time, and the
oven will use the residual heat to finish your dishes
without energy consumption. All current settings will be
displayed until the Cooking Duration time is over.
This function will not operate when the Cooking Duration
time is less than 15 minutes.
!
"Demo" mode
This mode is intended to be used in the shops to dem-
onstrate the oven functionality without any power con-
sumption except the oven lamp. To activate this func-
tion the appliance should be off.
1. Press button and
approximately 2 seconds (Fig. 20). The Electronic
Control beeps once.
2. When you press button
the message "DEMO" appears on the upper section
of the display (Fig. 21). You can then select any
cooking function, but the oven will not heat up. The
thermometer symbol will come on
flash nor rise.
To disable the demo mode:
Press button to switch off the oven, then press button
and at the same time for approximately 2
seconds. The Electronic Control beeps once and the
oven is ready to operate.
!
"Beep" Mode
You can choose to make The Electronic Control beep
each time that a button is pressed.
To enable this function, the oven must be off.
1. Press buttons and
3 seconds. The Electronic Control beeps once (Fig.
22).
To disable the "Beep" Function:
1. If the oven is on, press button
2. Press buttons and
3 seconds. The Electronic Control beeps once

Error code

The Oven Electronic Control does a continuous
diagnostic check of the system. If some parameters
are not correct, the control unit will stop the activated
functions and the corresponding error code will be
displayed.
For further details, refer to chapter "Something not
Working".
12
at the same time for
to switch on the oven,
#
, but it will not
at the same time for about
to switch it off.
at the same time for about
Fig. 20
Fig. 21
Fig. 22