Residual Heat Function; Demo Mode; Error Code - Electrolux ESOPMSS Instruction Booklet

Residual Heat Function

When a Cooking Duration time is set, the oven will
automatically switch off a few minutes before the end of
the programmed time, and use the residual heat to finish
your dishes without energy consumption. All current
settings will be displayed until the Cooking Duration time
is over.
This function will not operate when the Cooking Duration
time is less than 15 minutes.

Demo mode

This mode is intended to be used at the shops to
demonstrate the oven functionality without any power
consumption except the oven lamp.
To activate this function:
1. If the oven is on, press button
2. Press button and keep it pressed. While keeping
button pressed, turn the Time/Temperature knob
to . Keep the button pressed and the knob on
for 3 seconds. The system beeps once.
The oven is now set on "Demo" mode. When you switch
on the oven by pressing button
appears on the display.
All oven functions can be selected, but the thermometer
symbol will not flash and the cooking function number
will be replaced by the "
Follow the same procedure to deactivate the demo
mode.

Error code

The electronic programmer performs a continuous
diagnostic check of the system. If some parameters
are not correct, the control unit will stop the activated
functions and the corresponding error code (letter "E"
followed by number digits) will be displayed.
For further details, refer to chapter "Something not
working".
12
to switch it off.
, the " " indication
" indication.